Development of a Self-Powered Temperature Monitoring Wireless Node for Transmission Lines for Smart Grid Application

##plugins.themes.academic_pro.article.main##

Atulya Mishra
J. Sundara Rajan

Abstract

Increasing the safe operating temperature limits of the transmission line, by a small percentage above the present safe operating temperature limit can help in transmission of more power over existing lines and it would also help in avoiding huge investment and loss of time due to regulatory processes for establishment of new lines. Since the operating temperature is a critical parameter for transmission of the power, low cost sensors on high tension lines would enable data acquisition on real time basis for faster decision making. This is an alternative power source to the battery or solar panels. The results of laboratory experiments and data on simulation for the developed self-powered temperature, sag and tension monitoring system are presented and discussed in this paper. A comparison of two different methods of computation of temperature based on frequency and amplitude of output signal and cost benefit of the different methods of powering the wireless sensor nodes for transmission line application are also discussed.

##plugins.themes.academic_pro.article.details##

How to Cite
Mishra, A., & Sundara Rajan, J. (2018). Development of a Self-Powered Temperature Monitoring Wireless Node for Transmission Lines for Smart Grid Application. Power Research - A Journal of CPRI, 93–103. https://doi.org/10.33686/pwj.v14i1.142191

References

  1. Morgan VT. The thermal rating of overhead- line conductors, Part II. A sensitivity analysis of the parameters in the steady- state thermal mode. Electr Power Syst Res. 1983; 6:287–300. https://doi.org/10.1016/03787796(83)90040-8
  2. Morgan VT. The thermal rating of overhead- line conductors. 1. The steady- state thermal mode. Electr Power Syst Res. 1982; 5(2):119–39. https://doi.org/10.1016/03787796(82)90033-5
  3. Overhead transmission line ampacity ratings. American Transmission Company. CR-0061v07; 2012.
  4. Aluminum Electrical Conductor Handbook. The Aluminum Association. 3rd ed.; 1989.
  5. Current carrying capacity of overhead transmission line ACSR conductor. Uttar Pradesh Power Transmission Corporation Limited. Available from: http://www.upptcl.org/tech_info/current_carrying.htm
  6. Sathaye J, Dale L, Larsen P, Fitts G, Koy K, Lewis S, Lucena A. Estimating risk to California Energy Infrastructure from Projected Climate Change. CEC Publication CEC-5002012-057; 2011.
  7. IEEE Standard for Calculating the Current-Temperature Relationship of Bare Overhead Conductors. IEEE Std 7382012; 2013.
  8. Lindberg E. The overhead line sag dependence on weather parameters and line current. UPTEC W11 017; 2011 Dec.
  9. Elisabeth Lindberg , The Overhead Line Sag Dependence on Weather Parameters and Line Current, UPTEC W11 017 December 2011.
  10. Pan M-S dan, Tseng Y-C. ZigBee wireless sensor networks and their applications, Sensor Network and Configuration. Fundamentals. Techniques, Platforms, and Experiments. Springer-Verlag; 2007.
  11. Datasheet Pic16F1936. Available from: http://www.microchip.com/www.products/en/PIC16F1936
  12. Hoffmann K. Applying the Wheatstone Bridge Circuit. Darmstadt, Germany: Hottinger Baldwin Messtechnik GmbH; 2001.
  13. Datasheet Tarang UT-20 module. Available from: https:// fccid.io/document.php?id=1723546
  14. Roscoe NM, Judd MD. Harvesting energy from magnetic fields to power condition monitoring sensors. IEEE Sensors Journal. 2013 Jun; 13(6):2263–70. https://doi.org/10.1109/JSEN.2013.2251625
  15. Moghe R, Divan D, Lambert F. Powering low- cost utility sensors using energy harvesting, power electronics and applications (EPE 2011). Proceedings of the 2011, 14th European Conference; 2011 Aug 30-Sept 1. p. 1–10.
  16. USi inductive harvester. Power Donut 2. Available from: http:/www.USi-Power.com
  17. Bhuiyan RH, Dougal RA. Ali M. A miniature energy harvesting device for wireless sensors in electric power system. IEEE Sensors Journal. 2010; 10(7):1249–58. https://doi.org/10.1109/JSEN.2010.2040173
  18. Chang K, Kang S, Park K, Shin S, Kim H- S. Kim H. Electric field energy harvesting powered wireless sensors for smart grid. Journal of Electrical Engineering and Technology. 2012; 7(1):75–80. https://doi.org/10.5370/JEET.2012.7.1.75
  19. Guo F, Hayat H, Wang J. Energy harvesting devices for high voltage transmission line monitoring. IEEE Power and Energy Society General Meeting. 2011. p. 1–8. https://doi.org/10.1109/PES.2011.6039037
  20. Musavi M, Chamberlain D, Li Q. Overhead conductor dynamic thermal rating measurement and prediction. 2011 IEEE International Conference on Smart Measurements of Future Grids (SMFG) Proceedings; Bologna. 2011. p. 135–8.
  21. Gilbert JM, Balouchi F. Comparison of energy harvesting systems for wireless sensor networks. International Journal of Automation and Computing. 2008; 5(4):334–47. https://doi.org/10.1007/s11633-008-0334-2
  22. Williams CB, Yates RB. Analysis of a micro-electric generator for Microsystems. Proceedings of the Transducers 95/Eurosensors IX; 1995. p. 369–72. https://doi.org/10.1109/SENSOR.1995.717207
  23. Roundy S, Wright PK, Rabaey J. A study of low level vibrations as a power source for wireless sensor nodes. Computer Communications. 2003; 26(11):1131–44. https://doi.org/10.1016/S0140-3664(02)00248-7
  24. Zungeru AM, Ang L, Prabaharan SRS, Seng KP. Radio frequency energy harvesting and management for wireless sensor networks. Venkataraman H, Munteam G, editors. Green Mobile Devices and Networks- Energy Optimization and Scavenging Techniques. Boca Raton, Florida: CRC Press; 2012. https://doi.org/10.1201/b10081-16

Most read articles by the same author(s)